(Solved) Carprog full error “Damaged parts”


These are customer solutions to Carprog full V7.28 errors “Damaged parts -6 or 4” with detailed information like “Damaged parts – ARM7 +4 ARM7(master mcu) can’t be replaced contact seller to repair your device.”

 

Error:

Damaged parts -6

Damaged parts -4

Error message:

Damaged parts – ARM7 +4 ARM7(master mcu) can’t be replaced contact seller to repair your device.

carprog-Damaged-parts-1
Damaged parts -6

Demaged part -6 means you have broken mcz33290(ISO K Line Serial Link Interface)

carprog-Damaged-parts-3

If you look at 2 pictures when you click HW test you can see some ic-s with numbers on it, under 6 is mcz33290. You can take it from D1 adapter just for probe – there is mc33660 – its the same;

carprog-Damaged-parts-4

When the Carprog full  interface came with a problem “Demaged part -6”, tested with A9 and all was ok then.

 

Damaged parts -4

had a problem with my Carprog clone when connect it to computer and push “Hardware test”. the result is error in some “PIN” a final error is “Damaged 4 parts”.

carprog-Damaged-parts-2

Now make the A9 Adapter and everything will be OK in the end

carprog-Damaged-parts-6

carprog-Damaged-parts-7

carprog-Damaged-parts-8

carprog-Damaged-parts-9

carprog-Damaged-parts-10

Maybe, some guys may be unlucky if even do so. And that is another possible reason:

the Voltage is too large and heat is not good —> overheating then burn the 4th mcu chip. Replace the 4th chip using a heat gun or sent it back to seller to repair your carprog full.
NOTE: solutions above is from caprog users. You may be at risks to try it. Gm-Tech2.com just offers information here but won’t be responsible for it. Good luck!