VXDIAG VCX NANO For Ford and Mazda Review By Customer
By Mr.Richard Follett from U.S.A
Received item on Gm-Tech2.com
7 days after initial order, so not bad
To start with the software installation can be a little problematic to the point I Installed upto V96 only, however as I am using on an 2006 Fiesta it more than adequate for my needs.
I purchased the device because I needed to program an ebay purchased key to the vehicle PATS system as I only had one key when I brought the car and really wanted a spare in case of loss or damage
The device was able to delete all old keys from the system then and add 2 new keys, whilst I was there I did some software updates on the PCM.
Honestly it really is a good device and works perfectly once you get over the software issue.
A bit of advise with the software is use virtual machine (its easyier to delete and start again), and follow video guides found on youtube
Here is a quick guide for my success:
Use Virtual machine installer found on Ford IDS
CD V97, install VM then create a VM
Then on the virtual machine
Install calibration from V81 CD
Install V91 from V97 CD and reboot without opening software
Once rebooted open software and agree to 3 day licence, enter any details
Close software and Install V96 and reboot without opening
Once rebooted you can open software
Install software on CD V97 for the VX device
At this point I just installed deep freeze found on cd V97
Still playing with the vxdiag scanner, will report the test results in few days.