1.For 4D67,68,72(G), supports both G and H chip, tested on 2015 Camry
2.Programs both Toyo-ta G and Toyo-ta H chip vehicle via OBD2 port.
3.Free shipping to all over the world.
Get in the car and close the door, insert the key and turn on the key, insert the device into OBD. After the sound(Dee-), it will start to add the remote control.
After the sound ( Dee- Dee-),open the door, when hear the sound blaring. Press ‘ lock & unlock’ key at the same time. And press the’ lock’ key. If the blaring ends, It’s OK.
Note: Switch is on the right.(add remote control)
Get in the car and close the door, insert the main key into the lock and turn the key on,and then insert the device into the OBD. If it will sound twice, it will start to add transponder.
After the sound (Dee-Dee-), 2-3 minutes later, anti-theft light is on. And then remove the key( anti-theft light will flash), insert the new key and doesn’t need turn the key,anti-theft light will be off later.
Note: switch is on the left.( add transponder)
1pc x Toyo-ta G and H OBD Remote Key Programmer
Get in the car and close the door. Insert the original key and turn switch ignition to “ON” position.
Switch to “ADD TRANSPONDER” and insert the key programmer device into OBD connector. You will hear two beep sound (Dee-Dee), it will start to add the remote.
After two beep sound, you will hear continuously beep sound, the device indicator light will flash during the procedure.
After the sound (Dee- Dee-),open the door, when hear the sound blaring. Press “Lock & unlock” key at the same time. And press the “lock” key. If the blaring ends, it’s OK.
Insert the new transponder, no need to turn it, the indicator light will turn into flash.
The indicator will turn off after 60 seconds, then it’s done.